Publicidad
Idiomas disponibles
Idiomas disponibles
For a warm engine:
Follow the instructions for a 'cold engine' but return the choke to the off position as soon as
•
the engine starts.
•
If engine fails to start after 10 seconds leave for 1 minute and try again.
Stopping the engine
•
Set engine to idle position.
Allow to run for at least one full minute.
•
•
Switch off and remove ignition key.
Feeding speed adjustment
Flow control valve controls the motor rotation speed. When breaking branches with large diameter,
the flow rate can be appropriately lowered, and the speed can be adjusted up when the branches are
small.
A - Slow
B - Fast
Hydraulic motor rotation and stop
Two hydraulic motors are fixed on the feeding roller and rotate in opposite directions to roll the
wood into the chipping house.
Publicidad
