Electrical Hazards; Disposal; Tips And Useful Information - Talsa F14s Manual De Instrucciones

HYDRAULIC PISTON FILLERS F14/25/35/50
ALWAYS keep hands and hair away from moving parts when the machine is in use. There is the danger of crushing hands, fingers, etc. when closing the lid or when the piston is
raised while the lid is not completely open.
NEVER wear loose clothing or jewellery that could get caught on moving parts when the machine is in use.
DO NOT use the machine without wearing the protective gear required by law.
DO NOT leave the machine unattended while it is switched on or plugged to an electrical outlet. ALWAYS unplug the machine when it is not in use.
ALWAYS keep your work area well-lit and free of obstacles.
ALWAYS keep children, visitors and bystanders away from the machine while it is in use or plugged to an electrical outlet. NEVER allow children to operate the machine.
SHOULD THE MACHINE MALFUNCTION, PROMPTLY TURN IT OFF AND NOTIFY THE APPROPRIATE PERSONNEL.
ALWAYS follow the hygiene and cleaning instructions in this manual and the local sanitary codes in order to avoid contaminating the food mixture.
ALWAYS firmly grip both the transport handle (located at the machine's base) and the lid handle when moving the machine. DO NOT tilt the machine too far while it is balanced on
its wheels since it is heavy and there is a risk of personal injury or property damage if it tips over.

1.6 Electrical hazards

DO NOT TAMPER WITH THE MACHINE'S ELECTRIC SYSTEM. THIS MACHINE MUST BE INSTALLED ONLY BY A QUALIFIED ELECTRICIAN AND IN COMPLIANCE WITH
APPLICABLE NATIONAL, REGIONAL AND LOCAL ELECTRICAL CODES.
ALWAYS USE CAUTION WHEN WORKING ON THE MACHINE'S ELECTRICAL SYSTEM SINCE THERE IS A RISK OF ELECTRIC SHOCK DUE TO:
 DIRECT OR INDIRECT CONTACT WITH ELECTRIC CURRENT.
 IMPROPERLY INSTALLED DEFECTIVE OR DAMAGED ELECTRICAL PARTS.
BEFORE operating the machine, make sure that all phases are connected properly and that the machine is properly grounded and/or connected to a circuit leakage breaker and
thermal switch. Failure to do so could result in electric shock!
DO NOT tamper with the machine's electrical wiring or components after installation.
ALWAYS disconnect the machine from the electrical outlet before proceeding with cleaning, maintenance, or repairs.
To avoid damaging the power cord and possible injury, keep it away from areas where it may be stepped on or tripped over. DO NOT pull on the power cord to disconnect the plug
from the electrical outlet; always pull on the plug.

1.7 Disposal

Risk of damage to people and environmental hazards
The machine is composed of different materials. Observe local regulations on waste disposal. Instruct an authorized waste disposal company to dispose of waste correctly.

1.8 Tips and useful information

Additional operating instruction manuals may be obtained from your dealer. Your local dealer will gladly answer any questions you may have that are not addressed in this manual.
© Talsabell s.a. All rights reserved.
EN - 4
INSTALLATION AND OPERATING MANUAL
V-1.3 last revision: 07/2018