Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
This HVLP spray gun is not recommended for latex paint. The paint sprayer
will not properly spray unless the fan direction is either set vertically or
horizontal.
• Before using desired paint in the spray gun, spray a compatible thinner or
solvent through the gun to remove any containments and residue.
• Before adding paint, make sure all thinner or solvents are removed from the
spray canister.
• It is recommended that you pour the material through a filter into a smaller
container prior to filling the paint cup.
• Set up a piece of cardboard or other scrap material to use as a target to test
spray. Continue to test spray until the desired spray pattern is achieved.
1. Adjust the direction of the fan by
loosening the air cap ring by hand and
turning it to either the horizontal or
vertical direction. Tighten the air cap
ring by hand.
2. For a full spray pattern, turn spray pattern
adjustment knob (C) counterclockwise.
For a smaller pattern, turn spray pattern
adjustment knob (C) clockwise.
3. Loosen lock knob and turn the fluid
adjustment knob (E) fully clockwise until
closed.
WARNING
NOTE
1
2
3
11
Air Cap
Horizontal Fan
Vertical Fan
Air Cap Ring
C
E
Publicidad
