Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
4. Fill the Paint Cup (H) about 3/4 of the way
and secure the Cup Lid (I).
NOTE: Make sure the tether plug is pushed
into the vent hole on top of the cup lid
before operating the spray gun.
5. With the spray gun 6 in. to 10 in. away
from workpiece, spray a short burst while
turning the Fluid Adjustment Knob (E)
counterclockwise. Observe the spray
pattern on the workpiece and adjust the
Fluid Adjustment Knob (E) until desired
pattern/atomization is obtained.
NOTE
If the spray is too fine (caused by too
much air), reduce the air pressure or open
the Fluid Adjustment Knob (E) to spray
more paint. If the spray is too coarse or
spitting blobs, reduce the amount of paint
with the Fluid Adjustment Knob (E) or thin
the paint more (See Figure 5).
NOTE
Before spraying on workpiece,
practice a few minutes on a cardboard
target to ensure that the pattern size and
consistency are set correctly.
6. Keep the gun at a 90° angle to the
surface while spraying.
4
Counterclockwise
I
5
Pattern Consistency (Atomization)
6
6-10in.
12
Clockwise
Load paint
H
Paint too fine
Correct
Paint too coarse
Publicidad
