Placement Before Takeoff; Charging; Assembly - TYPHOON H Manual De Instrucciones

PLACEMENT BEFORE TAKEOFF

WARNING: Always operate Typhoon H in open areas (approximately
10000 square feet/930 square meters or more) that are free from people,
vehicles, trees and other obstructions. Never fly near or above crowds,
airports or buildings.
Never attempt to operate Typhoon H nearby tall buildings/obstructions that
do not offer a clear view of the sky (a minimum clearance of 100°).
Be sure to place Typhoon H on a level and stable surface before powering
ON the Ground Station and the aircraft.
IMPORTENT NOTE: STEP BACK APPROXIMATELY 26 FEET (8 METERS)
BEHIND THE Typhoon H.
NOTICE: Pilots are recommended to take off the aircraft under Angle
Mode. If the pilot takes off the aircraft under Smart Mode, make sure to
keep the aircraft 32.8ft (10m) away from the pilot.
NOTICE: For the best performance, the 5.8GHZ patch antenna should be
pointed to the aircraft for better performance.

CHARGING

Power the SC4000-4 charger from a 100-240V AC outlet using the AC
adapter/power supply, or from a 12V-16.8V DC accessory socket/cigarette
lighter receptacle in a vehicle using the included adapter.
Plug the aircraft battery into the charger port as illustrated.
A green blinking LED indicates the charger is powered on and ready to
charge, and a red blinking LED indicates the battery is charging. It will take
approximately 2.5 hours to charge a fully discharged (not over-discharged)
battery. A solid green LED indicates the battery is fully charged.
WARNING: All instructions
warnings must be followed exactly
to prevent property damage and/or
serious injury as the mishandling of
Li-ion/LiPo batteries can result in
fire.
FOR THE ST16 GROUND STATION
You can charge the ST16 battery by
using supplied USB cable
inserting it into the USB port on the
charger. It will take approximately 5
hours to charge a fully discharged
(not over-discharged) battery.
WARNING: Do not leave the battery
in the charger after the battery is
fully charged.

ASSEMBLY

STEP 1: ASSEMBLING THE ARMS
Unfold the motor arms and secure them until hearing a 'click'.
NOTICE: Press the 'PRESS' button
to fold the motor arms.
4
and
and
power