Powering On / Off; Starting/Stopping The Motors - TYPHOON H Manual De Instrucciones

STEP 2: INSTALLING THE PROPELLERS
IMPORTANT NOTE: Always ensure propellers are installed properly. The motors are
extremely powerful, meaning that if the device is misused there is a risk of material
damage, serious injury and even fatal injury.
Mount the propellers on the motors and note the 'A' and 'B' given on the motor
arms. This distinction between 'A' and 'B' refers to propeller 'A' and 'B'. Mount
propeller 'A' on motor 'A' and propeller 'B' on motor 'B'，press and rotate propel-
lers in the direction the [ ] points to, and the propellers will be locked.
A
B
A
STEP 3: INSTALLING THE FLIGHT BATTERIES
Push the battery into the battery compartment with the Yuneec logo facing upwards
until hearing a 'click', which means the battery is installed successfully.
NOTICE: Gently open the battery cap to the maximum
degree (to a position where is almost horizontal with
the GPS cover), then you can pull the battery out.
STEP 4: REMOVE THE PROTECTIVE COVER AND INSERT THE SD CARD
Carefully remove the protective cover from the camera lens. Insert the
included 16GB card or any Class 10 microSD card (U3 speed capable of 4K
data rates) from 16GB to 128GB.
NOTICE: Press and hold the
center button on the propeller
and rotate the propeller in the
B
direction the [
then you can disassemble the
propellers.
A
B

POWERING ON / OFF

NOTE: ALWAYS turn on the ST16 Ground Station and allow it to boot up
BEFORE turning Typhoon H on (and ALWAYS turn Typhoon H off BEFORE
turning off the ST16 Ground Station).
Place Typhoon H on a level and stable surface then power on the ST16 Ground
] points to,
Station. Press and hold power button on Typhoon H. Release the button when the
aircraft emits a rising tune. DO NOT TOUCH OR MOVE THE Typhoon H UNTIL THE
INITIALIZATION PROCESS IS COMPLETE. The gimbal camera will spin to the front
position.
NOTICE: If the main LED blinks red slowly, the initialization has failed. The aircraft
needs to be powered on again. To power off the aircraft, press and hold the power
button until the aircraft emits a falling tune.
NOTICE: After hearing a rising tune, the main LED indicator will blink green for 1
to 2 seconds once with flight battery fully charged, yellow with half charged and
red with low voltage.

STARTING/STOPPING THE MOTORS

NOTICE:Only with sustainable GPS or IPS activated or GPS being turned
off, the motors can be started or stopped by pressing the
START/STOP button.
NOTICE: After the GPS is turned off, IPS will be turned off automatically and the
indoor positioning function will be disabled.
OPTION 1
Press and hold the START / STOP button for about 3 seconds to start, and about 2 seconds
to stop the motors. Step back approximately 26 feet (8 meters) behind Typhoon H,
make sure the ST16 Ground Station is in the Angle mode. When there is suitable
GPS signal for both the ST16 Ground Station and Typhoon H, or IPS for the aircraft,
you can start the motors.
OPTION 2
With the GPS of both the aircraft and the ST16 Ground Station locked, the pilot
can select Camera/Task switch icon, and tap the Take Off on the task row. Make
sure the pilot is more than 5 meters away from the aircraft and then slide the icon
on the screen, the aircraft will take off and hover at default height.
5
GPS
9
VOL
12.6V
FSK
WiFi FSK
WIFI
CHA
POS
CHA
POS
00 : 35 : 25