cecotec BONGO M30 CONNECTED Manual De Instrucciones página 62

ENGLISH
3. OPERATION
Assembly and configuration
Fig. 25
1. Fold out the handlebar, lock it and lower the kickstand.
2. Install the handlebar on the stem.
Tighten the screws on both sides of the stem with the T-shaped Allen key.
3.
After assembly, press the power button to check for proper operation.
4.
Charge your scooter
Fig. 26
The scooter is fully charged when the LED light on the charger changes from red (charging) to
green (continuous charging).
Open the rubber charging port cover.
1.
Connect the charger to the charging port.
2.
3. When charging is complete, re-attach the rubber cover.
How to ride
Warning:
use helmet, elbow and knee pads. Please read the instructions carefully before
using the product. Do not modify the braking system. Check the instructions for further
information.
Switch on the scooter and check the power indicator.
1.
Place one foot on the deck and push off the ground with the other foot. When the
2.
scooter starts to coast, place both feet on the platform and press the accelerator. Note:
Acceleration will start when the coasting speed exceeds 5 km/h.
The accelerator automatically switches off when the scooter is at a complete standstill.
3.
To restart the scooter, repeat step 2.
4. Release the accelerator and the Kinetic Energy Recovery System (KERS) will automatically
start to brake slowly; press the brake lever to brake suddenly.
Tilt your body in the direction of steering when turning and slowly turn the handlebar.
5.
Control panel
- On: one short press.
- Off: a long press for 2 seconds.
- Light: two short presses.
- Drive mode: one short press.
PEDESTRIAN mode: In this mode, the scooter can reach 6 km/h.
1.
COMFORT mode: In this mode, the scooter can reach 15 km/h.
2.
3. SPORT mode: In this mode, the scooter can reach 25 km/h.
- Cruise control: three short presses.
- No. of rolls: five short presses.
- Gyroscope: hold down the brake lever and seven short presses.
62
ORIGINAL MANUAL TRANSLATION