Publicidad
Idiomas disponibles
Idiomas disponibles
Read the following important safety information before using this equipment to avoid
serious injury or death and to avoid damage to equipment or property.
WARNING
ELECTRIC SHOCK HAZARD:
• Plug unit into a properly grounded electrical
receptacle of the correct voltage, size, and
plug configuration. If plug and receptacle
do not match, contact a qualified electrician
to determine and install proper voltage and
size electrical receptacle.
• Turn OFF power switch, unplug power cord,
and allow unit to cool before performing any
cleaning, adjustments, or maintenance.
• DO NOT submerge or saturate with water.
Unit is not waterproof. Do not operate if
unit has been submerged or saturated
with water.
• Unit is not weatherproof. Locate unit
indoors where ambient air temperature
is a minimum of 21°C (70°F).
• Do not clean unit when it is energized or
hot.
• This unit is not "jet-proof" construction. Do
not use jet-clean spray to clean this unit.
• Do not steam clean or use excessive
water on unit.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed
or worn.
• Do not attempt to repair or replace
a damaged power cord. Cord must
be replaced by an Authorized Hatco
Service Agent or a person with similar
qualifications.
• This unit must be serviced by qualified
personnel only. Service by unqualified
personnel may lead to electric shock or burn.
• Remote mounted control enclosure must
be mounted on a vertical wall and installed
in vertical position. Mounting control
enclosure in horizontal position may
result in collection of liquids and lead to
an electric shock.
• Use only Genuine Hatco Replacement
Parts when service is required. Failure to
use Genuine Hatco Replacement Parts
will void all warranties and may subject
operators of the equipment to hazardous
electrical voltage, resulting in electrical
shock or burn. Genuine Hatco Replacement
Parts are specified to operate safely in the
environments in which they are used. Some
aftermarket or generic replacement parts do
not have the characteristics that will allow
them to operate safely in Hatco equipment.
HSBFCEM1-0523
IMPORTANT SAFETY INFORMATION
FIRE HAZARD:
• Locate unit a minimum of 25 mm (1")
from combustible walls and materials.
If safe distances are not maintained,
discoloration or combustion could occur.
• Do not use harsh chemicals such as
bleach (or cleaners containing bleach),
oven cleaners, or flammable cleaning
solutions to clean this unit.
Make sure food product has been heated
to the proper food-safe temperature before
placing on the unit. Failure to heat food
product properly may result in serious
health risks. This unit is for holding
preheated food product only.
Make sure all operators have been instructed
on the safe and proper use of unit.
This unit is not intended for use by children
or persons with reduced physical, sensory,
or mental capabilities. Ensure proper
supervision of children and keep them away
from unit.
Hatco Corporation is not responsible for
actual food product serving temperature. It
is the responsibility of the user to ensure
that food product is held and served at a
safe temperature.
Do not place food product directly onto
hardcoat surface. Food product must be
wrapped, boxed, or on a food pan.
This unit has no "user-serviceable" parts.
If service is required on this unit, contact
an Authorized Hatco Service Agent or
contact the Hatco Service Department at
+1-414-671-6350.
3
WARNING
Publicidad
