Publicidad
Idiomas disponibles
Idiomas disponibles
EN
This tool is equipped with an adjustable 6 position belt hook for
right and left handed operators. The hook will safely support the tool
when hanging from joists and rafters.
Rotate the knurled knob to adjust opening or to switch from right
to left side. Move black plastic cap to alternate side to complete
assembly.
TOOL OPERATION
This tool is equiped with a dual-pur-
pose light on the nosepiece. The
light will indicate that the electronic
controls are energized while pro-
viding illumination of the workpiece
in low light situations. The light
will flash three times when the
selector switch is switched to either
sequential or contact actuation. This
lets the user know that the tool is
ready to fire a fastener. The light will
remain on for ten seconds when the
trigger is pulled or the work contact
element is depressed.
This tool is equipped with depth-
of-drive dial. Turning the dial to the
right will countersink the fastener,
turning the dial to the left will leave
the fastener up or raised. Drive a
fastener into a scrap piece of wood
to test depth.
Turning the dial in the direction
shown in the image will result in
the fastener driving deeper into
the wood.
Whenever possible, hold the tool at a
right angle to the work surface.
Indicator LED ON
14
Always turn the tool off before stor-
ing. As an added protection feature,
the tool will automatically turn off 34
minutes after the last activation.
If a nail jam occurs, the red light at
the mode selector switch will flash
red. The tool will attempt to recover
after battery is removed and reset.
If the jam is severe, the driver blade
will lock in place by design and
the red flashing light will not clear.
Contact an authorized service center.
Should a minor fastener jam
occur:
Turn the tool off by depressing the
selector switch towards either mode
symbol for approximate ly 1 second,
then remove battery.
Insert battery and turn tool back on
via mode selector switch. Tool will
attempt to recover.
Should a severe fastener jam
occur:
Turn the tool off by depressing the
selector switch towards either mode
symbol for approximate ly 1 second,
then remove battery.
Remove fasteners from magazine.
Wear safety glasses when removing
magazine.
Point nose of tool away from self
and others.
Follow the unloading instructions to
remove fasteners from magazine.
Remove the magazine (F-15XP) or
keep the magazine open (F-16XP
and F-18XP).
Remember! The Fusion tool is
charged with compressed air in a
factory sealed chamber.
Do not push on the driver with any
force or use a hammer to strike the
driver while it is visible.
Remove jammed fastener with a
pliers or screwdriver.
Do not tamper with the drive
assembly.
Re-attach the magazine or close the
magazine.
Insert battery and turn tool back on
via mode selector switch. Tool will
attempt to recover.
If tool indicates a jam again via
red light, return tool to authorized
service center for evaluation
Publicidad
