Publicidad
Idiomas disponibles
Idiomas disponibles
Additional Safety Warnings
To prevent eye injuries, always wear EN166 safety glasses with permanently attached rigid, hard plastic side shields.
Be sure everyone in your work area is wearing the same type of safety glasses.
DANGER
The Fusion tool is charged with compressed air in a sealed chamber. Prior to any service or repair, release the charge
of pressurized gas.
The pressurized air must be released prior to service. Major components such as the piston/driver assembly, gearbox,
piston stop and guide body are all part of the drive assembly.
Deliberate tampering with the drive assembly may result in the release of the driver.
Any repair or upgrade requiring access to the pressure chamber may be handled by an authorized Senco dealer or
service center.
Disconnect tool from battery when:
• Outside of the operator's supervision or control.
• Performing maintenance or repair
• Clearing a jam
• Moving the tool to a new location
• Adjusting depth of drive
With battery disconnected, make daily inspection to assure free movement of workpiece contact element and trigger. Do not use tool if work-
piece contact element or trigger sticks or binds.
Always remove finger from trigger when not driving fasteners. Never carry the tool with finger on or under trigger. Tool will eject a fastener if the
workpiece contact element is bumped and the trigger is pulled.
Drive fasteners into work surface only; never into materials too hard to penetrate.
Do not drive fasteners on top of other fasteners or with the tool at too steep of an angle; the fasteners can ricochet and hurt someone.
When using tool, care should be taken due to possibility of tool recoil after a fastener is driven. If workpiece contact element is unintentionally
allowed to re-contact work surface following a recoil, an unwanted fastener may be driven. Therefore, allow tool to recoil completely off work
surface after a fastener is driven to avoid this condition. Do not push workpiece contact element on work surface until a second fastener is
desired.
Please review triggering options.
Do not drive fasteners close to the edge of the work surface. The workpiece is likely to split and the fastener could fly or ricochet and hit
someone.
Never use any part of the tool (i.e., the cap or mainbody ) as a hammer. The tool may activate or become damaged and result in an unsafe
condition.
Keep hands and other body parts away from the area shown in the circle to avoid possible injury during operation.
MADE IN TAIWAN / FABRIQUE EN TAIWAN /
FABRICADO EN TAIWAN
Kyocera Senco Europe
Pascallaan 88, 8218 NJ Lelystad, The Netherlands
SAFETY WARNINGS
7
Do not use tool without Danger Label on tool. If
label is missing, damaged or unreadable, contact
your SENCO representative to obtain a new label
at no cost.
EN
Publicidad
