Publicidad
Idiomas disponibles
Idiomas disponibles
TO CHARGE BATTERY
Place battery pack in charger.
Press down on battery pack.
When battery pack is connected, red light will turn on.
When your battery pack becomes 80% charged, the red light will
stay on and the green light will flash.
When battery pack is fully charged, the red light will turn off and the
green light will turn on.
Authorized
Authorized
Service
Service
Center
Center
TOOL OPERATION
Red and green light flashing indi-
cates defective battery pack.
Return battery pack to your
nearest SENCO Authorized
Service Center for inspection or
replacement.
Solid red indicates that the battery
is charging.
After normal usage, 45 minutes of
charge time is required to be fully
charged.
A maximum charge time of 1 hour
is required to recharge a completely
dis-charged battery pack.
Maintenance charge is indicated
when the red light turns off while the
green light flashes.
The battery pack will become slight-
ly warm to the touch while charging.
This is normal and does not indicate
a problem.
Tips for maintaining Max life:
Charge the battery pack before it is completely discharged. Always
stop tool operation and charge the battery when you notice less
tool power.
Never recharge a fully charged battery. Overcharging shortens the
battery service life.
Charge every 4-6 months.
15
Battery is constructed with 4 LED
lights built into a panel on the bat-
tery pack. These 4 LEDs reveal the
state of charge and indicate possible
problems inside the battery pack.
State of Charge:
Press raised green button on battery
pack to check charge.
Red Flashing = 0–15% charge
Red On = 16–25% charge
Red and Yellow On = 26–50%
charge
Red Yellow and Green On = 51–75%
charge
All On = 76-100% charge
EN
Publicidad
