Publicidad
Idiomas disponibles
Idiomas disponibles
Removing and refitting the door panels
The glass panels can be removed from the oven door to allow
more thorough cleaning.
Removal
Removing the oven door See the section Removing the oven
1.
door. Lay the oven door on a cloth with the handle facing
downwards (Fig. A).
First turn the two screws at the bottom anticlockwise, then the
2.
two screws at the top, also anticlockwise (Fig. B).
Remove the cover (Fig. C).
3.
The parts that have been removed must not be washed. Clean
the panels with a glass cleaner and a soft cloth.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If your meal is not successful, please refer to section . We have
tested the recipe for you in our cooking studio. Here, you will
find useful cooking tips and tricks for cooking, baking and
roasting.
Malfunction
Possible cause Remedy/information
The oven does
The circuit
not work.
breaker is
defective.
Power cut.
Oven not hot.
Dust on the
contacts.
:
Risk of electric shock!
Repairs that are not carried out properly are dangerous.
Repairs must only be performed by one of our after-sales
service technicians.
10
Look in the fuse box to see
if the circuit breaker is
defective.
Check whether the kitchen
light and other kitchen
appliances are working.
Turn the control knobs sev-
eral times to the left and
right.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Refitting
Place the cover back in position (Fig. A).
1.
First retighten the two screws at the bottom, then the two
2.
screws at the top (Fig. B).
Fitting the oven door See the section Fitting the oven door.
3.
Do not use the oven again until the panels have been
correctly fitted.
Caution!
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Replacing the bulb in the oven ceiling light
If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 40 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
:
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the oven when it is cold to prevent
1.
damage.
Unscrew the glass cover by turning it anti-clockwise.
2.
Publicidad
