IPC Yanmar 1450 D Manual De Instrucciones página 49

Debris bin raising switch (fig. C, ref. 8): enables raising and lowering of the debris bin
Bin raising/lowering enabling button (fig. C, ref. 9): this button must be used together
with the debris bin raising switch.
Emergency button (fig. C, ref. 10): press to stop the machine.
Side brush switch (fig. C, ref. 11): this button enables/disables operation of the side
brushes, but these are activated only when the centre brush is in operation.
Multifunction lights (PETROL and DIESEL):
(
fig. C, ref. 12) OK LED: lights up when the machine is started
(fig. C, ref. 13) MOTOR OIL LED: comes on when the pressure in the internal combustion
engine drops below the standard value.
(fig. C, ref. 14) ALTERNATOR KO LED: comes on when the alternator no longer delivers
current when the internal combustion engine is on.
(fig. C, ref. 15) INTERNAL COMBUSTION ENGINE AIR FILTER CLOGGED LED: comes
on when the air filter is clogged (OPTIONAL)
(fig. C, ref. 16) FUEL LED: comes on when the machine is running on the fuel reserve
(fig. C, ref. 17):
Timer records the working hours of the internal combustion engine or
drive pump in the BATTERY version
Centre brush pressure regulation handle (fig. A, ref. 2): regulates the pressure of the
brush on the floor. The handle should be operated with the centre brush STATIONARY.
(fig. D, ref. 1)
Accelerator handle (PETROL and DIESEL version) : by setting this lever
to MINIMUM or MAXIMUM, you can regulate the speed of the internal combustion engine.
When working, it must always be set to MAXIMUM.
Side brushes adjustment knob (fig. D, ref. 2): this knob sets the number of revolutions
of the side brushes (turn clockwise to reduce the speed)
Machine movement pedal (fig. A, ref. 3): pivoting device, press forwards to move the
machine forwards, press the back to move the machine backwards
Service brake/parking brake pedal (fig. B, ref. 3): acts mechanically on the two brake
drums on the back wheels.
Battery charge indicator (BATTERY version) (fig. C, ref. 19), to improve battery
protection, the machine is fitted with a charge indicator. This safety device consists of a
series of eight LEDs which provide a constant indication of charge level (capacity
indicator) and shut the pump down immediately when the charge drops below the
minimum permitted level. When this occurs, the red LED comes on.
The number of yellow LEDs lit indicates the remaining charge. One LED corresponds to
a charge of about 10%.
When the minimum permitted charge is reached, the left yellow LED flashes to warn that
the pump is about to shut down.
The red LED indicates that the minimum permitted charge has been reached and at the
same time, the pump shuts down.
Pump motor thermal cutout tripped lights (BATTERY version) (fig. C, ref. 20-21),
these two LEDs come on when the electric motors overheat.
If one of these LEDs comes on, stop work immediately and allow the motor to cool down.
If the problem reoccurs, have the machine checked by qualified personnel.
M1= drive pump motor
M2= functions pump motor
6.2. Preparing the machine for work
IMPORTANT
Before starting work, wear overalls, ear protectors, non-slip shoes, mask to protect
the respiratory tract, gloves and all other personal protection devices necessitated
by the work environment.
ENGLISH
10