IPC Yanmar 1450 D Manual De Instrucciones página 56

MAINTENANCE SCHEDULE
A: On receipt
B: Twice a week
C: Each week
D: Every 20 hours
E: Every 50 hours
F: Every 100 hours
G: Every 150 hours
H: Every 300 hours
I: Every 400 hours
I: Every 400 hours
CHECK
Centre brush : check for nylon
cord or rope wrapped around
the brush and remove if
necessary
Centre brush : check the state
of wear of the brush
Side brushes : check the state
of wear of the brushes
Flaps/bin gasket : check the
state of wear of flaps and
gaskets
Dust filter : check that the filter
is clean and undamaged
Tyres : check that the tyres are
in good condition and the sides
are free from cuts
Steering : grease the steering
chain
Battery : check the acid level
Hydraulic circuit : check oil
level
Hydraulic circuit : check pipes
and hoses for damage
Internal combustion engine :
change engine oil
Internal combustion engine :
change filter oil
Internal combustion engine :
change air filter
Internal combustion engine :
clean air filter
Internal combustion engine :
check engine oil level
General control : check the
tightness of nuts and screws
A B C D
See engine instructions
See engine instructions
See engine instructions
See engine instructions
See engine instructions
E F G H
ENGLISH
I
17