Publicidad
Idiomas disponibles
Idiomas disponibles
Anleitung_4309025:_
19.07.2010
GB/
MT
The length of the screws to be used varies,
depending on the thickness of the table top.
Install the fretsaw on a work table made
■
from solid wood. This will avoid excessive
noise caused by vibrations.
Mark the drill holes. Use the fretsaw as a
■
template for this purpose.
Drill 4 holes with a diameter of 9 mm into the
■
work table and the rubber base.
Screw the fretsaw to the table using the
■
mounting points (Fig. 3/12, Item 16) and in
the following sequence (Fig. 4):
A) Fretsaw
B) Rubber base
C) Work table
D) Flat gasket
E) Washer
F) Hex nut
G) Hex nut
H) Hex screw
Tighten the hex nut (F) and secure it with a
■
second hex nut (G).
7.3 Assembly
Important! Always pull out the power plug
before carrying out any maintenance or
conversion work on the fretsaw.
7.3.1 Mounting the saw blade guard and the
sawdust blower facility (Fig. 6/7/8)
Slide the saw blade guard (5) onto the
■
holder (4).
Push the knurled screws (3) through the
■
oval holes of the saw blade guard (5) and
tighten.
The saw blade guard can be affixed at
■
different heights using the knurled screws.
Mount the blow-off device (1) as shown in
■
Figure 8.
56
15:26 Uhr
Seite 56
7.3.2 Changing the saw blade
(Fig. 1/6/9/10/11/14)
Important
To avoid injuries attributed to inadvertent
startup: Always move the switch to the "0"
position and pull the power plug out of the
socket outlet before removing or changing
the saw blade.
Turn the tightening screw (9)
■
counterclockwise to remove the tension
from the saw blade (17).
Unscrew the left cover (7). To do this, open
■
the cover of the storage box (22) and
remove the screws (C) (Fig. 6). (It is also
possible to change the saw blade without
removing the left cover. This, however,
requires a little bit of finesse.)
Remove the saw blade from the upper saw
■
blade holder (24) while pressing down on
the upper pendulum arm.
Remove the saw blade from the lower saw
■
blade holder (25).
Lift the saw blade up and out of the table
■
insert (26).
Insert new saw blade in reverse order.
■
Important: Always fit the saw blade with the
teeth facing downward in the direction of
the saw table.
The saw blade can be inserted into groove a
(Fig. 9,10) or b (Fig. 9,11):
Groove a:
For cuts longitudinal to the arm
Groove b:
For cuts transverse to the arm
Tension the saw blade by turning the tightening
screw (9) to the right. When the tightening
screw becomes a little harder to turn, turn it
approximately 3 times more
(3 full turns) to ensure that it is properly
tensioned.
Reinstall the left cover (7) (only if removed).
■
Publicidad
