Publicidad
Idiomas disponibles
Idiomas disponibles
Generate a new code of transmission:
The manufacturer provides the remote con-
trol ready to use with the factory default
codes.
If you want a new generation of codes, fol-
low these steps: Press and hold simultane-
ously the three buttons shown in the figure
(1-2-3) until the LED (5) will start to flash, at
this point, the remote control will perform a
scanning various frequencies available when
the buttons are released, the LED (5) will stop
flashing and the remote control will record
the frequency scanned at that time.
If you want a different frequency, repeat the
procedure (after restoring the factory config-
uration), the frequency chosen will depend on
how long the buttons are held down.
WARNING! This operation deletes the ex-
isting codes in a definitive manner.
Restoring the factory configuration:
If you have made a change in the transmis-
sion code and want to retrieve the original
factory, follow these steps: Press and hold si-
multaneously the three buttons shown in the
figure (1-2-3) until the LED (5) lights with a
steady light, at this time the remote control
has restored the original frequency of the
factory.
WARNING! This operation deletes the ex-
isting codes in a definitive manner.
ATTENTION - WARNING - MAINTENANCE
The battery should be replaced every year to
guarantee optimal range of the transmitter.
To replace the battery, remove the back cov-
er, then remove the battery taking care not
to damage or deform the connection plates
and introduce a new one by inserting the in-
dicated polarity. Coin Cell Battery, Lithium
CR-2032 3V battery. The used battery should
be disposed of in the appropriate contain-
ers. Operating Frequency 433.92MHz 4096
combinations. The product complies with the
requirements of Directive R&TTE Directive
99/5/EC
.
MAINTENANCE
An accurate maintenance guarantees good
functioning and long-lasting performance.
A special care must be paid with grease fil-
ters: to remove the grease filter please follow
the instructions given in the 'USES' section,
according to the model chosen.
Remove the grease filter by pulling its handle.
To reinsert the grease filter after the clean-
ing, just perform the opposite operation.
Attention: after refastening the stainless
steel panel make sure that it is properly fixed.
To clean the appliance itself tepid water and
neutral detergents are recommended, while
abrasive products must be avoided.
For steel appliances specialized detergents
are recommended (please follow the instruc-
tions mentioned on the product itself to ob-
tain the desired results).
To replace the lamp, (E200/150, E200/110,
E210/150 V1350, E210/110 V1100, 205/110
V1100) remove the lamp (Fig. 9) and replace
it with a lamp of the same kind.
Substitution of the LED bar:
Using an appropriate tool, remove the LED
bar from its seat (refer to Fig. 13), disconnect
it electronically using the appropriate con-
nector then substitute it with a LED bar with
same characteristics.
23
Publicidad
