Tunturi FitRow 40 Manual Del Usuario página 23

Explanation Display functions
Scan
Automatically scan functions for : Time, Count,
ODO, Dist, RPM & Cal.
Each display will be hold 4 seconds
Time
Automatically accumulates workout Time when
exercising.
Count (cnt)
Automatically accumulates the number of steps
when exercising.
Odo
Automatically accumulates the number of strokes
for all exercise sessions.
Dist
Distance for the workout.
- M Indicates parameters in meter.
RPM
Rowing speed for the workout.
- Rowing-strokes Per Minute.
Cal
Automatically accumulates Calorie burnt when
exercising.
NOTE
• This data is a rough guide for comparison of
different exercise sessions which cannot be
used in medical treatment
Explanation of buttons
MODE
- Press MODE button to select console functions;
Time, Count, Dist ODO & Cal.
- Push and hold for 4 seconds to reset: Time,
Count, Dist & Calorie.
SET
Set the values for: Time, Count, Dist & Calorie
when not in scan mode.
- Press SET button to set console in goal input
mode.
- Press MODE to select goal you like to set. (the
selected goal will blink when able to set value.)
- Press SET Button to higher the goal input, hold
SET button to higher the value fast.
- Press RESET button shortly to reset the
changed selected goal.
- Press MODE Button to active next optional goal
to be set.
Time + 1 min
CNT +10
DIST +100
CAL + 1
ODO (cannot change)
RPM (cannot change)
NOTE
• When you set a goals the set goal value will
Count down in active mode.
• When goal is reached the console will
notify by 4 dual acoustic beep signals. The
reached value will now Count up starting
from "0".
• You can set more than one goal, all goals
will notify when goal is reached.
RESET
- Push and hold for 4 seconds to reset: Time,
Calorie & Count.
NOTE
• Total Count can only be reset by a batteries
exchange.
Extra notes
- If the display is faint or shows no figures, please
replace the batteries.
- The monitor will automatically shut off if there is
no signal received after 4 minutes .
- The monitor will be auto-powered on when
starting to exercise push button w/signal in.
- The monitor will automatically start calculating
when you start to exercise and will stop
calculating when you stop exercising for 4
seconds .
Cleaning and maintenance
The equipment does not require special
maintenance. The equipment does not require
recalibration when it is assembled, used and
serviced according to the instructions.
WARNING
• Do not use solvents to clean the equipment.
English
(1~99)
(1~9990 )
(1~999 )
23