Philips One HY1200 Manual Del Usuario página 4

Brushing instructions
Please follow the brushing instructions for the best
experience.
1 Wet the bristles and apply a small amount of
toothpaste.
2 Place the toothbrush bristles against the teeth at a
slight angle (45 degrees) (Fig. 11), pressing gently
to make the bristles reach the gumline or slightly
beneath the gumline.
Note: The bristles should slightly flare.
3 Press the power button to turn on the toothbrush.
4 Brush your teeth with back and forth strokes so
that the bristles reach all surfaces of the teeth.
Change to another section when the QuadPacer
beeps. Continue this motion throughout the
2-minute brushing cycle.
5 To clean the inside surfaces of the front teeth, tilt
the brush vertically and make several up-and-
down strokes (Fig. 12).
6 After you have completed the brushing cycle, you
can spend additional time brushing the chewing
surfaces of your teeth and areas where staining
occurs (Fig. 13). You can also brush your tongue,
with the toothbrush turned on or off, as you
prefer.
Your power toothbrush should be safe to use on
braces (brush heads wear out sooner when used on
braces) and dental restorations (fillings, crowns,
veneers) if they are properly adhered and not
compromised. If a problem occurs, please follow up
with a dental professional.
Battery status
This Philips One toothbrush is designed to provide at
least 60 brushing sessions after it has been fully
charged for 8 hours. This allows sufficient charge for 1
month's usage if you brush 2 times a day (each
session lasting 2 minutes).
When the battery light indicator flashes amber it is
time to charge your Philips One (see chapter Charging
your Philips One). The table below specifies the
battery states:
Number of
brushings
remaining
40-60 brushings White- solid
7-39 brushings
≤6 brushings
0 brushings
remain
Note: When the battery is completely empty, the
toothbrush turns off. The toothbrush will not turn on
until battery is recharged. Toothbrush does not turn
on while charging.
Note: Battery usage time is expected to reduce over
product lifetime.
Cleaning
You should clean your toothbrush and accessories
regularly to remove toothpaste and other residue.
Failure to clean your product may result in an
unhygienic product and damage to it may occur.
Warning: Do not clean product or accessories in
dishwasher, microwave, with chemicals or with
boiling hot water.
Toothbrush handle
1 Remove the brush head and rinse the metal shaft
area with warm water (Fig. 14). Make sure you
remove any residual toothpaste.
2 Wipe the entire surface of the handle with a damp
cloth.
Note: Do not tap the handle on the sink to remove
excess water.
Cleaning brush head
1 Rinse the brush head and bristles after each use.
2 Remove the brush head from the handle and rinse
the brush head connection with warm water at
least once a week.
Cleaning travel case or brush head travel
cap
Rinse the travel case or brush head travel cap weekly
with warm water and wipe clean with a damp cloth.
Cleaning the USB-A charging cable and
charging port
1 Use compressed air to clean the charging port on
the toothbrush handle and connector on the USB-
A charging cable.
2 Use a slightly dampened cloth to wipe the USB-A
charging cable then leave to air dry completely.
Note: Avoid contact of the charging port and
connections with water. After cleaning, make sure the
USB-A charging cable is completely dry before you
connect it to a USB power supply unit.
Storage
If you are not going to use the product for a long
time, clean it (see 'Cleaning'), charge it fully, and store
it in a cool and dry place away from direct sunlight.
Replacement
Brush head
Replace the brush heads every 3 months to achieve
optimal results. Only Philips One brush heads are
compatible with Philips One.
Locating the model number
Remove brush head from handle. Look at the top of
the handle near the metal shaft for the model number
(HY120X).
Warranty and support
If you need information or support, please visit
www.philips.com/support or read the international
warranty leaflet.
Battery
indicator
White- fades up
and down
Amber- flashing 5 beeps after
Amber- flashing 5 beeps x 2
Beep sound
-
-
brushing