Fronius MHP 280i G CMT Manual De Instrucciones página 39

Contents
General
General
Proper use
Original equipment and tools
Functions of the torch trigger - Standard
Up/Down function
JobMaster function
Deactivating the left or right torch trigger
Safety
Warning notices on the device
Safety
Start-up
MTG d, MTW d - Fitting wearing parts to the torch body
Note regarding the inner liner with gas-cooled welding torches
Inserting a steel or CrNi inner liner into the torch body
Checking the clamping nipple
Inserting a plastic wire guide into the torch body
Fitting wearing parts inside the drive
Changing the outlet nozzle
Fitting the inner liner from the wire buffer to the FSC
Attaching the torch body
Fitting inner liner to wire buffer
Connecting the welding torch to the wirefeeder
Connecting the welding torch to the power source and the cooling unit
Threading the wire electrode
Setting the contact pressure
Changing the torch neck, rotating the torch neck
Removing the torch body
Attaching the torch body
Rotating the torch body
Care, maintenance and disposal
General
Maintenance at every start-up
Every time the wirespool/basket-type spool is changed
Recognising faulty wearing parts
Changing or cleaning the wire guide wire buffer and sliding contact
Fitting the inner liner from the wire buffer to the drive unit
Troubleshooting
Troubleshooting
Technical data
General
Gas-cooled welding torch - MHP 280i G CMT
Water-cooled welding torch - MHP 400i W CMT
40
40
40
40
41
41
42
42
43
43
44
46
46
46
47
47
48
49
51
52
54
55
56
56
57
58
59
59
60
61
62
62
62
63
63
64
65
67
67
72
72
72
73
39