All local and national laws and European standards must be
met when installing and using the appliance. In Italy, refer to
health authority regulations
It is necessary to refer to regulations in force in each country. If
installing in an apartment building, check with the management
DEVICES
gas heating equipment (e.g. gas boilers, stoves, and equipment
served by an extraction hood) as the stove may cause a vacuum
units work.
the stove (unless already installed, an appropriate differential
POSITIONING
safety conditions:
distances, technical and construction-related provisions
must be appropriately insulated
through passage.
INSTALLATION
must be resistant to high temperatures (high temperature silico-
ne or mastic).
nel is outside, it must be appropriately insulated.
diameter it must be improved by entering a pipe that has a sui-
-
nected to the solid fuel appliances must be cleaned once a year
Failure to regularly inspect and clean the stove increases the
reigniting the stove. The stove is designed to work under any
weather conditions. In case of particular conditions, such as
strong wind, the safety system may be activated, which results
in the stove being extinguished. If this happens, do not operate
the stove with the safety devices disabled. If the problem per-
not operate the appliance while the safety devices are disabled.
TYPICAL EXAMPLES
Fig. 1
A:
B:
-
roof gutter
C-E:
CHIMNEY POT
- an internal cross-section at the base, which is the same as that
- an outlet cross-section which is no smaller than twice that of
- its position must be high enough to catch the wind and avoid
downdraft areas in turbulent wind, it must be high enough to
catch the wind and avoid downdraft areas in turbulent wind.
- 32
-
-
-
-
-
-
Fig. 2