Siemens SITRANS FCT030 Instrucciones De Manejo página 4

Vertical rotation
1. Loosen locking cap at end of mounting bracket by three turns.
2. Carefully loosen and rotate transmitter into desired position (15° steps).
3. Firmly tighten locking cap (torque: 25 Nm).
Connecting
WARNING
As long as the device is energized, the lid of the housing on the sensor connection area may only be opened by qualified
personnel.
Before removing the terminal cover, the auxiliary power must be switched off from all poles.
Following installation, the terminal cover must be screwed back on again.
1. Remove blind plugs where required and mount cable glands.
2
3
①
Input/output connection (channels 2 to 4)
②
Power supply connection
③
Current output/HART connection (channel 1)
2. Remove lid lock screw for terminal connections lid.
3. Remove lid for terminal connections.
Application terminals
A label with a graphic showing the terminal connections is placed at the back of the terminal connections lid.
4
1
SITRANS FCT030 transmitter
A5E03650800-02, 03/2012