1. Insert wiring tool hook into receptor slot.
2. Press wiring tool wedge into top slot to spread clamp plates.
3. Insert wire.
4. Release wiring tool.
Power supply
1. Flip open power supply terminal protection cover.
2. Remove cap and ferrule from cable gland and slide onto cable.
3. Push cable through open gland and cable path.
4. Restore ferrule and tighten cap to lightly hold cable in place.
5. Connect ground to terminal
①
L/+
②
N/-
③
6
and power to terminals L/+ and N/- using wiring tool in the manner shown below at right.
1
2
3
SITRANS FCT030 transmitter
A5E03650800-02, 03/2012