Siemens SITRANS FCT030 Instrucciones De Manejo página 8

Note
Active or passive current output is preselected at ordering.
Note
Load
Current output (channel 1): < 500 Ω (HART ≥ 230 Ω)
Inputs and outputs (channels 2 to 4)
1. Remove cap and ferrule from cable gland and slide onto cable.
2. Push cable through open gland and cable path.
3. Restore ferrule and tighten cap to lightly hold cable in place.
4. Signal cable screen is folded back over outer sheath and grounded beneath cable clamp.
5. Connect wires to terminals using wiring tool.
12
11
Active current output
Termination example for channel 3
6. Tighten cable gland.
Note
Active or passive current output is preselected at ordering.
Factory Software
configuration configuration
Signal output Analog, pulse,
frequency or
Active
status output
If status: alarm
class, alarm
number, one-
stage dosing, or
two-stage dosing
8
⑫
IO[3] (common)
⑪ IO[3]+ (active)
Channel Channel
2 3
X X
13
12
Passive current output
Channel
4
X
-
⑬
IO[3]- (passive)
⑫ IO[3] (common)
IOXp-
IOXC
U
0
IOXa+
+
SITRANS FCT030 transmitter
A5E03650800-02, 03/2012