Publicidad
Idiomas disponibles
Idiomas disponibles
8 Parameterization
Parameter
Reset configuration settings
Switching channel 1, output signal IO-Link, PNP, NPN, push-
Switching channel 1, limit value/
window HIGH (SP1/FH1)
Switching channel 1, switching be-
havior (OU1)
Switching channel 1, mode
Switching channel 1, hysteresis
Switching channel 1, release point/
window low (rP1/FL1)
Switching channel 1, switching de-
lay time (ds1)
Switching channel 1, release delay
time (dr1)
Switching channel 1 pulse width
modulation (PWM) – period time
Switching channel 2, output signal PNP, NPN, push-pull
Switching channel 2, limit value/
window HIGH (SP2/FH2)
Switching channel 2, switching be-
havior (OU2)
Switching channel 2, mode
Switching channel 2, hysteresis
Switching channel 2, release point/
window Low (rP2/FL2)
Switching channel 2, switching de-
lay time (ds2)
Switching channel 2, release delay
time (dr2)
Switching channel 2 pulse width
modulation (PWM) – period time
Teach function selection
36
Default setting
–
pull, push-pull PWM
Input range:
0 to 100.0 % (25)
High-active (MAX, HNC,
FNC), low-active (MIN,
HNO, FNO)
Single point, window (FH,
FL), two point
Input range:
0 to 100.0 % (0)
Input range:
0 to 100.0 % (–)
Input range:
0.3 to 60 s (0.5)
Input range:
0,3 bis 60 s (1.0)
50 to 1000 ms (–)
Input range:
0 to 100.0 % (25)
High-active (MAX, HNC,
FNC), low-active (MIN,
HNO, FNO)
Single point, window (FH,
FL), two point
Input range:
0 to 100.0 % (0)
Input range:
0 to 100.0 % (–)
Input range:
0.3 to 60 s (0.5)
Input range:
0,3 bis 60 s (1.0)
50 to 1000 ms (–)
Switching channel 1,
switching channel 2
Description
Button for resetting the configuration
that has been made.
Setting according to variant ordered,
see order code.
Sets the limit value that must at least
be available to change the switching
status.
Input range value > switching chan-
nel value 1 release point/window
Low (rP1/FL1)
Setting of the switching behavior as
high- or low-active.
–
–
Input range value < switching chan-
nel value 1 limit value / window HIGH
(SP1/FH1)
Time display in 0.1-second steps.
Time display in 0.1-second steps.
Period duration in relation to mea-
sured value.
Setting according to variant ordered,
see order code.
Input range value > switching chan-
nel value 2 release point/window
Low (rP2/FL2)
–
–
–
Input range value < switching chan-
nel value 2 limit value/window HIGH
(SP2/FH2)
Time display in 0.1-second steps.
Time display in 0.1-second steps.
Period duration in relation to mea-
sured value.
Selection of output channel on which
the teach function is to have an ef-
fect.
Publicidad
