Publicidad
Idiomas disponibles
Idiomas disponibles
11
Shutdown
11 Shutdown
11.1
Dismounting
Requirements:
•
The plant has been de-pressurized, de-energized and secured against being switched on again.
•
The device is media-free.
Aids
NOTICE!
Damage to the device tip due to improper handling.
The device tip may be damaged during dismounting.
Check the device tip for notches or grooves.
11.2
Decontamination
Requirements:
•
The device is disassembled.
•
Suitable protective equipment has been set up.
•
A suitable cleaning agent is available.
•
A cleaning area for flushing and neutralizing all parts that come into contact with the medium is pre-
pared.
Procedure:
1. CAUTION! Only use cleaning agents that are compatible with the materials used to make the device.
Thoroughly flush and neutralize all parts that come into contact with the medium using a suitable
cleaning agent.
2. For return to the manufacturer: chapter 11.3 "Returns", Page 44.
3. For disposal: chapter 11.4 "Disposal", Page 44.
11.3
Returns
Procedure:
1. The
supplementary sheet for product returns
close it with the shipping documents and attach it to the packaging, ideally on the outside.
2. Use the original packaging or a suitably secure container for sending the device.
11.4
Disposal
•
Do not dispose of the device or replaced parts in the trash after use.
•
Delete programs and data stored on the device.
•
Remove batteries, if any, if this can be done without damaging the device.
•
Dispose of the device and the packaging material in a responsible and environmentally friendly man-
ner.
•
Observe the country-specific laws and regulations for waste treatment and disposal.
In accordance with Directive 2012/19/EU on Waste from Electrical and Electronic Equipment, manufac-
turers are obliged to offer the option of returning waste equipment. Request the return from the manu-
facturer.
44
Open-end wrench or ring spanner
must first be completed correctly and signed. Then en-
Publicidad
