Publicidad
Idiomas disponibles
Idiomas disponibles
Parameter
System command
Event setting, auto-calibration er-
ror
Event setting, pollution degree
Status display according to
Brightness of the status display
Pollution degree
Filter time constant
Temperature unit
Load default settings (rES)
Diagnostics
Parameter
Device status
Error counter
System command back-to-box
System command locator start
System command locator stop
Current diagnosis information
Last diagnosis information
Simulation mode
Measured value simulation
Service commands reset all ser-
vice parameters
Service command reset operating
hours
Default setting
Teach SP1
Teach SP2
False
False
IO-Link, NE 107, user-de-
fined
Eco-mode, medium, high,
maximum
Selection list:
low, medium, high (–)
Input range:
0 to 100 s (–)
°C, °F
–
Default setting
–
–
–
–
–
–
–
On, Off
Input range:
0 to 100 % (–)
–
–
8 Parameterization
Description
Teach button in the software to teach
in switching point 1 of the selected
switching channel.
Teach button in the software to teach
in switching point 1 of the selected
switching channel (for window or two
point mode).
Setting to transmit an event in the
case of an error during auto-calibra-
tion.
Setting to transmit an event in the
event the pollution degree is exceed-
ed.
–
–
–
–
–
Reset to default settings.
Input option
Shows information about the device
status.
Shows information on the number of
registered errors.
IO-Link-specific button for resetting
the default settings.
IO-Link-specific button to have the
installed device flash in the plant.
IO-Link-specific button to have the
device installed in the plant no longer
flash.
Display of current diagnostic mes-
sage.
Display of the last diagnostic mes-
sage.
Activate or deactivate simulation
mode.
Input of a simulated measured value.
Button that resets all service param-
eters listed in the sub-menu.
Button that resets the operating
hours counter.
37
Publicidad
