Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
10. Pour in the glass stones, and the top of the ignition pro-
tection cover should be exposed.
Note that the top of the burner must be exposed and not
buried.
11. As shown in the figure
1. First, insert the convex surface of the T-shaped silicone
heater plate into the M6X16 hexagon socket head cap screw
and push the gasket all the way to the end of the screw.
2. Next, insert the screws inserted into the silicone gasket in
step 1 into the holes in the four corners of the glass in the
same direction in succession.
3. Place the convex surface of the silicone gasket on the
screw from the back towards the glass, and press the screw
so that it is in close contact with the silicone gasket on the
back.
Material needed
x 16
FF
x 32
HH
12-1. Insert the screw previously placed in step 11 and two
screws at one end of the silicon gasket tempered glass into
the bracket holes at both ends of the top of the enclosure,
screw in with M6 blind nuts from the inside and adjust the
position of the tempered glass to the centre.
12-2. Assemble the remaining pieces of tempered glass to it
in turn by following the steps shown.
12-3. Adjust the spacing at the bottom of each glass to be
uniform, then screw the screws until the silicone gaskets on
both sides of the glass are fully tightened to the glass, and
then continue tightening the nuts for half a turn.
Material needed
x 8
GG
10
Note that the
upper part of
this part should
be exposed and
not buried.
11
HH
FF
12
26
English
G
C
GG
infiniton.es
Publicidad
