Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
4. Install the gas cylinder holder on the inner side of the back
plate with two M4 X8 screws.
Material needed
x 2
DD
5. Install the rear cover on the left and right side walls with
four M6X12 hexagonal screws (note that the gas cylinder hol-
der must be located at the bottom.
Material needed
x 4
AA
6.1. Insert the pivot shaft in the lower left-hand corner of the
front door into the hole in the chassis pivot shaft.
6.2. Straighten the front door, then place the top of the box
plate over the left and right side plates of the box, and insert
the pivot shaft at the top left of the front door into the pivot
shaft hole at the bottom left of the top plate of the box.
6.3. Adjust the position of the enclosure body top plate and
the left and right side plates so that the mounting screw ho-
les on the bottom of the enclosure body top plate are alig-
ned with the mounting holes on the left and right side plates,
and tighten the enclosure body top plate from the inside with
four M6X12 hex screws.
Material needed
AA
x 4
4
J
5
6
P
24
English
DD
H
AA
AA
infiniton.es
Publicidad
