Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
7. Install the control panel hole on the right side in the middle
of the top of the left and right side plates, fix it with four M6X12
hex screws, close the front door, adjust the clearance be-
tween the front door and the top plate of the enclosure, then
open the front door and tighten the screws. Adjust the insta-
llation so that the front door can have an even gap with the
top plate and enclosure chassis. If the control panel cannot
be placed smoothly between the left and right side plates,
loosen screws A and B in the previous step, and then tighten
screws A and B after assembling this step.
Material needed
x 4
AA
8. Position the burner head valve in front of the top of the
housing body, and screw the burner head to the top plate of
the housing body with four M5X8 screws.
Material needed
x 4
BB
9. Insert the valve extension rod into the valve stem through
the round hole in the control panel, then insert the nut on the
inside of the extension rod and push it in. Then insert a union
pin into the anti-drop hole of the extension rod that commu-
nicates with the valve from the inside and bend the union
pin.
Material needed
II
x 1
7
AA
P
8
BB
D
9
E
F
25
English
II
infiniton.es
Publicidad
