Descargar Imprimir esta página

Motorola DLR1020 Guia Del Usuario página 66

Publicidad

Idiomas disponibles

Idiomas disponibles

MN003596A01-AB
Chapter 12 : Cloning Mode
3 Plug one side of the cloning cable mini USB connector to the first SUC, and the other end to the
second SUC.
NOTE: During the cloning process, no power is being applied to the SUC. The batteries
are not charged. Only data communication is being established between the two radios.
4 Turn on the Target Radio and place it into one of the SUCs.
5 To turn on the Source Radio, press PTT and Volume Down buttons simultaneously for three
seconds.
You hear Cloning Mode beeps, and "Cloning Mode, Serial" voice prompt from your radio.
6 For the Source Radio, power on the radio with the following sequence:
1 Press the PTT and Volume Up buttons at the same time while turning the radio on. Wait
three seconds before releasing the buttons, and you hear "Clone Mode Serial" voice prompt
from your radio.
2 Place the Source Radio in its SUC. Press and release the Volume Up button.
You hear "Pass" or "Fail" voice prompt from your Source radio.
7 To exit the clone mode when the process is completed, press the Power button, or long press
the PTT button.
12.4
Cloning Mode Status Indicator
Press and hold both the PTT button and Volume Down button at the same time, while turning on the
radio to enter cloning mode.
Table 21: Cloning Mode Status Indicator
Cloning Mode Status
Cloning Mode (by default is
Serial)
Switch to Wireless Cloning [in-
itiated by (-) button]
Switch to Serial Cloning [initi-
ated by (-) button]
Clone [initiated by (+) button] –
Cloning in progress
Cloning Successful
Cloning Fail
12.5
Troubleshooting Cloning Mode
When and where to use:
The radio audible voice announces "Fail" indicating that the cloning process has failed. In the event
that cloning fails, perform each of the following steps before attempting to start cloning process again.
Procedure:
1 Ensure that the batteries on both radios are fully charged and engaged properly on the radio.
66
LED Indicator
Double Blink Red
Double Blink Red
Double Blink Red
Solid Red
Not Available
Not Available
Voice Prompt or Tone
"Clone Mode, Serial"
"Wireless"
"Serial"
Cloning beeps
"Pass"
"Fail"

Publicidad

loading

Este manual también es adecuado para:

Dlr1060