Invacare Matrx LIBRA Manual Del Usuario página 9

4.0 C
ARE AND
WARNING! Risk of injury or damage W
• Do not continue to use this product if problems or damage are discovered;
• Corrective maintenance can be performed at or arranged through your service
provider
4.1 Inspection
Frequent visual inspection of all components, including upholstery materials, fluid sac,
foam and any hardware or plastics, should be performed to identify any breakage,
deformation, punctures, wear and tear or compression. Replace damaged/worn
components if necessary.
4.2 Cleaning and Disinfection
WARNING! Risk of damage W
To avoid infectious exposure, inspect cushion thoroughly and properly clean
and disinfect any materials soiled with blood or other bodily fluids.
CAUTION! Risk of damage
• DO NOT use cleaning and disinfecting agents with abrasive, staining, or
polymer-damaging properties such as phenols, alcohols, or bleaches. Chlorine
solutions used even in low concentrations on a regular basis can diminish the
life of the cover.
• Chosen cleaning agents and disinfectants must be compatible with one another
in order to effectively protect the materials on which they are applied.
• Keep clear of open heat sources during cleaning.
OUTER COVER:
General Cleaning
The knitted fabric side of the cover can be wiped with a damp absorbent towel,
cloth, or paper towel. Remove all gross contamination from surface (i.e. food
particles, urine, feces, blood). Spot-clean with mild soap and water.
Cleaning and Disinfection Instructions
The infection control cover can be cleaned and disinfected with ready-to-use
disinfecting wipes 3M, Virox Accel TB, Accel Prevention, PREempt, OPTIM 33 TB,
or other wipes with similar formulations. Note that the surface should be cleaned first,
with all gross contamination (i.e. urine, feces, blood) first removed with absorbent
material (cloth or paper towel). Ensure the coated surface of the cover is clean by
wiping with one of 2-in-1 cleaning and disinfecting wipes mentioned above.
To disinfect, liberally wipe the surface with the ready-to-use disinfecting wipe again.
Avoid pooling of the disinfectant and ensure the disinfectant is distributed equally
over the cover surface. Wipe dry after recommended dwell time (refer to each
disinfecting products manufacturing instructions). It is best practice to wipe the
surface with a damp cloth, mild soap, and finally a damp cloth no matter what
disinfectant is used.
M
AINTENANCE
- 9 -