Teac VRDS-20 Manual Del Usuario página 10

Music Search Operation
@ Music search using </>
buttons (MUSIC SKIP)
The beginning of any tune can be easily
located using the (<< and m1 music
skip buttons during playback or in the
pause mode. This operation is indicated
clearly in the TRACK display.
To skip to the next tune
When the m4 button is pressed during
play, the pickup will skip to the beginning
of the next tune.
Each time the ®t button is pressed, the
pickup skips forward by one tune and
play starts from the beginning of that
tune.
bat
7 1 aan
| 1 Uw LI UIs
© This operation is possible even in the
program playback mode. However, only
programmed tunes will be detected.
To skip back to the previous tune
Press the <4 button.
The player will skip back one tune each
time the It button is pressed. If this
button is pressed in the middle of a tune,
the player will skip back to the beginning
of the current tune. To make it skip back
to the previous tune, the button must be
pressed twice.
In this way, the player can be returned to
the beginning of the first tune on the disc.
hex
_{
cy
ca
a)
@ This operation is possible even in the
program playback mode. However, only
programmed tunes will be detected.
@ Music search using << / >>
buttons (SEARCH)
During playback or in the pause mode,
hold down the me button to move the
playing position quickly in the forward
direction, and hold down the <4 button
to move quickly in the reverse direction.
During the manual search operation,
sound will be audible but the output level
will be lowered. This lets you search for
any required portion while checking the
sound.
When the desired position is reached,
release the button to reenter the previous
mode.
© During the normal play mode (or in the
programmed playback mode), when
the player reaches the end of the disc
(or program) after the ms button has
been pressed, the player enters the
pause mode whereas when the player
reaches the beginning of the disc (or
program) after the <4 button has
been pressed, the player enters the
playback mode.
@ In the single repeat mode, holding the
<< of m> button will move the
playing position within the current
tune.
© Inthe program playback mode, holding
the me or << button will move to
the next or previous programmed tune,
respectively.
-0-
@ Index search
Index Search is possible using the index
= and — buttons. This allows direct
access to any desired points on discs
where INDEX codes have been encoded.
d track within
Index code is
+ or — button
d Index number
appears in the INDEX display.
Press —™ to increase the INDEX
number, and press + to decrease
the INDEX number.
wm
| ru
INDEX number
The player skips to the selected INDEX
point and playback starts from the
point at which the designated Index
code is encoded.
e If the Index number designated
exceeds the highest Index number in
the selected track, playback will begin
from the portion with the highest Index
number in the track.
@ While the player searches the
designated Index point, the time
counter displays no time information.
During this interval, no control buttons
except for the stop and the open/close
buttons can be engaged.
@ Direct track search
Select a required track number using the
4 or P+ button with the player in the
stop mode. Pressing the play (m) or
pause (1) button allows the player to
search the selected track and play it.
@ Direct index search
After selecting a required track number
using the ke or mB button with the
player in the stop mode, select the
required index number using the + or
— button. Playback starts from the
selected index point.