Teac VRDS-20 Manual Del Usuario página 11

Time Counter Display
Time mode indicator
cecere CTC Oc Sa I
Time counter
The time counter shows various time
readouts, as follows. First, when the disc
tray is closed with the disc loaded, the
total disc playback time © will be
displayed for several seconds.
During playback shows the elapsed time
© of the current tune (track), but no time
mode indicator will light. However, each
time the time button is pressed, the time
counter shows a different time, in the
order, the remaining time of the current
tune © - the total remaining time of the
disc ® - after which the elapsed time is
displayed again.
© Total disc playback time
In the stop mode, when no tunes have
been programmed, pressing the time
button will recall the total playback
time (and the total number of tunes on
the disc) for several seconds.
© Elapsed time display
When playback begins, the elapsed
time of the tune being played is
displayed in minutes and seconds.
@ Remaining time display (REMAIN)
Displayed when the time button is
pressed once. This provides an easy
check of the remaining time of the tune
being played.
® Total remaining time display
(TOTAL REMAIN)
Displayed when the time button is
pressed twice. This provides an easy
check of the total time required to
finish the disc. The time displayed is
the total remaining playback time from
the position being played, to the end of
the disc; the counter counts down to
"0:00" during playback.
When a "Pause" is programmed within
the program, the remaining time up to
the point at which "Pause" is
programmed will be displayed.
@ Innormal playback mode, if a tune with
a number higher than 20 is being
played, the remaining time will not be
displayed in the time counter even
when the time button is pressed.
e If tunes with numbers higher than 20
are included in the program, the
remaining time and total remaining
time may not be displayed in the time
counter depending on the tune being
played.
Auto Spacing
When this function is activated, an
interval of approx. 4 seconds will be
inserted between tunes automatically, so
they are played back with a fixed spacing.
To activate this, press the auto space
button so that the AUTO SPACE indicator
lights in the display.
When the auto space button is pressed
again, the indicator goes off and the auto
spacing function is released.
Fade In/Fade Out
During the playback mode, press the fader
button. ("FAdE" is indicated in the display.)
The player will fade out gradually and the
player enters the pause mode.
1 ) 1
or 5
To continue playback, press the fader
button again; the player will fade in
gradually.
© This function is usable only when LINE
OUT is connected.
Display Function
When the display button is pressed during
playback, all the display indicators that
are lit go off except the power indicator
lamp.
Even when this is done, the player will
continue playback.
© When this function is activated, if any
Operation button is pressed, the
display will come on for approx. 4
seconds.
es |
Timer Playback
Although there is no Timer control switch
on the front panel, the unit has a timer
controlled function. This lets you start
playback at any desired time when an
optional audio timer is used.
1. Connect the unit and your stereo
system to an audio timer as shown in
the diagram.
2. Set the power switches of all
components to ON.
3. Load a disc into the unit, and close the
door.
4. Set the input selector of the amplifier
to the position corresponding to the
terminals to which the unit is
connected.
5. Adjust the volume to the required
level with the amplifier's volume
control.
6. Set the preset time when playback is
to start the audio timer.
After the timer is set, the power to the
amplifier and the unit will be cut off.
@ Playback will start automatically at the
time preset on the audio timer.
Timer Connection
Audio timer
To AC outlet of
the timer
Pre-amplifier
To amplifier's
AC outlet