Kärcher SC 4 Manual Del Usuario página 27

Assembling the accessories
Figure
A
Position and fit the swivel wheel and
other wheels.
Figures y
B C
Place the open end of the accessory on
the jet nozzle.
Place the open end of the accessory
onto the steam gun until the steam gun
release key clicks into place.
Figure
D
Connect the extension tubes to the
steam gun.
a) Fit the 1st extension tube onto the
steam gun until the steam gun release
button engages.
The connection tube is connected.
b) Fit the 2nd extension tube onto the
1st extension tube.
The connection tubes are connected.
Removing the accessories
DANGER
Figure
E
1. Move the selector switch backward
to select the steam volume. The steam
lever is blocked.
2. Press the unlock key and separate
the parts.
Filling with water
The water container should be filled to
maximum height.
CAUTION
Damage to the equipment
The use of unsuitable water may cause
the nozzles to clog or damage to the water
level indicator.
Do not use pure distilled water. Instead,
use no more than 50% distilled water
mixed with tap water.
Do not fill with condensation from the dryer.
Do not fill with rainwater.
Do not fill with detergent or other additives
(such as fragrances).
Figure
1
The water container can be removed for
filling or can be filled directly on the machine.
Removing the water container
for filling
Figure
1a
Pull the water container out upward.
Fill the water container vertically with
tap water or with a mixture of tap water
and no more than 50% distilled water,
up to the «MAX» mark.
Place the water container and press
down until it clicks into place.
Filling the water container directly on
the equipment
Figure
1b
Fill a container with tap water or with a
mixture of tap water and no more than
50% distilled water, and then fill the
water container through the filler neck
up to the «MAX» mark.
Equipment start-up
Note
If the steam boiler contains little water or
is empty, the water pump engages and
pushes water from the water container
into the steam boiler. The filling process
can take several minutes.
Note
The equipment closes the valve briefly
every 60 seconds, so you will hear a
gentle click. This repeated closing keeps
the valve from getting blocked. This does
not affect steam application.
Place the equipment on a firm base
Plug the power connector into an outlet.
Figure
2
Press the ON switch.
The green heater control light flashes.
Figure
3
Wait for the green heater control light to
stay lit without blinking.
27