Kärcher SC 4 Manual Del Usuario página 31

Dirt on the carpet glider, as well as heat
and moisture, can cause damage to
the carpet.
Before application,
resistance and
discretely on part of the carpet with a small
steam volume.
Observe the carpet
cleaning instructions.
Before using the carpet glider, make sure
the carpet has been vacuumed and stains
have been removed.
Before application and after breaks in
operation due evaporation in a drain
(without floor cloth/with accessories),
remove any
(condensate) from the equipment.
Only use the carpet glider with a floor cloth
on the floor nozzle.
Perform steam cleaning using the carpet
glider with a gentle steam stage.
Do not direct the steam continuously at
the same spot (maximum 5 seconds) to
prevent excessive moisture and the risk of
temperature damage.
Do not use the carpet glider on deep-
pile carpets.
Secure the carpet glider to the floor
nozzle
Figure
G
1. Attach the floor cloth to the floor nozzle.
See the Floor Nozzle chapter.
Figure
H
2. Slide the floor nozzle with slight pressure
until it fits onto the carpet glider.
3. Starting to clean carpets.
Remove the carpet glider from the
floor nozzle
ATTENTION
Foot burns
The carpet glider
when steaming.
Do not use the carpet glider barefoot or
wearing sandals or open-toed shoes.
Only use the
appropriate footwear.
test the
steam consequences
manufacturer's
accumulated water
may get
carpet glider
Figure
H
1. Press the flange of the carpet slider
down with the tip of your shoe.
heat
2. Raise the floor nozzle.
Nozzle for cleaning windows
Application Uses
– Windows, mirrors.
– Glass in general.
– Other flat surfaces.
– Before using the glass cleaning nozzle
for the first time, first wash the glass with
the hand nozzle and microfiber sleeve to
remove grease.
– Apply steam evenly over the glass from
approximately 20 centimeters away.
– Dry the window from top to bottom with
the window cleaning nozzle. Always dry
the nozzle and the inside of the window
with the cloth.
hot
with
31