mspa Soho P-SH069 Manual De Instrucciones página 15

Spa Tub and Air Bladder Repair
Use the enclosed repair patch to repair any puncture:
1. Clean and dry the area to be repaired thoroughly
2. Apply the glue to the PVC patch and quickly attach it onto the damaged surface. (Glue is not included)
3. Smooth the surface to remove any air bubbles and allow it dry for 5-10 minutes
NOTE: Glue is not included.
1
Storage and Preparation for Future Use
1. Drain and clean the spa by following the "Drainage" and "Spa Cleaning" sections.
2. Refer to the instructions to deflate the spa tub and air bladder.
3. Make sure all the spa components and accessories are thoroughly clean and
dry before storage. Air-dry the spa tub in the mild sun for an hour before folding.
4. Fold the spa tub loosely and avoid any sharp corners to prevent damage or
leakage to the spa liner.
5. Prepare new additional cartridge for next time use.
6. Store the spa and accessories in a dry, temperature-controlled environment,
between 0°C and 40°C (32°F - 104°F). We recommend storing the spa with
desiccant.
7. The original packaging is recommended for storage.
8. After long-term storage, fill the spa with clean water and sanitizer, and turn on the
FILTER for at least 1 hour before use.
PRECAUTIONS FOR SEASONAL USE
Inflatable hot tubs are made of reinforced PVC material, whose nature decides the hot tubs are easily affected by weather and temperature. Please do pay
special attention when using the spa under different seasonal conditions.
In Summer / Sunny days
Direct sunshine and hot weather will both lead the spa liner to expand.
●
To extend the service life of the spa, it is suggested to place the spa in a sheltered place.
●
Please check the air pressure regularly. The manometer should always point to the Green section when spa is filled with water. When leaving the spa
outdoors unattended for long periods of time, release some air until the manometer points to the Yellow section. This will prevent the spa liner from
expanding too much due to rising temperature during the daytime.
●
To protect your skin from sunburn, it is highly recommended to enjoy the spa in the morning or evening when the sunlight is milder and temperature is
more comforting.
●
Check the water temperature and consider lowering it for the times when the spa is not in use. Turn off the heater entirely if not using the spa for an
extended period of time.
In Winter
Inflation
Low temperature will harden the PVC material and make it more fragile.
●
The new spa might have been stored or transported at a low temperature (below 4°C / 39°F) before it is unfolded. Put the package indoors or
somewhere warm for 12 hours to soften the material before use.
●
The lower the temperature is, the more air the spa tub will require, and the longer the inflation will take. After water is heated to a much higher tempera-
ture, the air inside the chamber will get swollen. To shorten the inflation period, and to reduce the expansion of the spa liner, we suggest inflating the spa
at a temperature higher than 15°C / 59°F. If the ambient temperature is below 0°C / 39°F, the spa should not be inflated.
2
pin hole pin hole
15
3
SUN
®