mspa Soho P-SH069 Manual De Instrucciones página 17

PROBLEM
Auto-off 10 minutes
Unidirectional threshold is not open
NO BUBBLE
Control panel failure
Inflation knob is in <ON> position
Filter stuck by dirt or other objects
FILTER PUMP
DOES NOT WORK
Filter system failure
SPA TUB IN AN
Extra air pressure by strong sunlight
ABNORMAL
SHAPE
Spa inlet/outlet connection not securely tight
SPA LEAKING
Drainage valve is not closed completely
Water leaks from the spa pool body
Air valve got loosen
SPA LOSES AIR
PRESSURE
Hole or split on the spa tub
Water has been used too long
Insufficient filtering
WATER NOT
CLEAN
Dirty filter cartridge
Improper water maintenance
CAUSE
17
SOLUTION
Wait for 10 minutes
Contact local MSpa Service Center
Contact local MSpa Service Center
Turn the knob to <OFF> position and turn on the bubble button again.
Clean or replace the filter cartridge
Contact local MSpa Service Center
Check the air pressure and release some air if necessary.
During hot weather, it is recommended to
check if it is necessary to release some air to avoid any possible
damage to the spa pool
Tighten the inlet and outlet connection
Close the drainage valve. Contact the MSpa Service Center, if spa
is still leaking
Repair the leaking hole/spilt with the repair kit material
Inflate the spa till the Yellow section of the manometer is pushed
out. Make sure the valve is screwed tightly. Replace the valve if
necessary.
Put soap water in a squirt bottle and spray
on seams. If there is a leak, small bubbles will come out. After you find
the leak, clean and dry the leaking area, then use the repair patch
comes with your spa to repair. Check the repair section on P15.
Change the water
Increase filtration frequency
Clean or replace the filter cartridge in time
Refer to the chemical manufacture's instruction