mspa Soho P-SH069 Manual De Instrucciones página 16

Heating and Heat Preservation
In cold weather, heating the water up will take much more time. It is suggested to:
●
Fill the spa tub with lukewarm water (not higher than 40°C / 104°F) to get it heated it more quickly.
●
Use ground mat and inflatable bladder for better heat preservation effect.
●
When the outdoor temperature is below 4°C(39°F), even when not using the spa, as long as it is filled with water, the heater should always be turned on
(or put the spa in stand-by mode) to prevent water from freezing.
●
Your spa is equipped with an Anti-icing System. Put the spa in stand-by mode, when the water temperature falls below 1°C/33.8°F, the heater runs
automatically until the water is heated up to 3°C/37.4°F. This will help prevent water from freezing. If you are not going to use the spa in near future，
please disassemble the spa and store it following the storage procedure.
In Rainy days
Si coloca el spa al aire libre, no lo use cuando llueve.
Si coloca el spa bajo un refugio para la lluvia, no encienda la función de burbujas, ya que la lluvia del aire también será absorbida por la bomba, provocan-
do que el generador de burbujas se humedezca y se oxide, lo cual podría provocar una avería y anular la garantía.
Se recomienda colocar el enchufe y la toma de corriente en un lugar no expuesto a la lluvia para evitar daños por la acumulación de agua.
DISPOSAL AND ENVIRONMENTAL PROTECTION
This marking indicates that the product should not be disposed of with other household waste. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle the product responsibly to promote the sustainable reuse of
material resources. Information on disposal can be obtained from your local authorities.
To return your used device, please use the return and collection systems or contact the retailer where the product was purchased for
environmentally safe recycling.
TROUBLESHOOTING
ERROR CODE CHART
LED READING
Water temperature is lower than 0°C degree or exceeds 55°C (131°F)
E0
Temperature sensor failure
Waterflow switch failure
E1
Filter failure
Water level is not at minimum water line
PROBLEM
Power failure
GFCI is off
NO DISPLAY ON
THE WIRED
GFCI broken
CONTROLLER
Press the Reset button, Control Panel is not displayed
Temperature set too low
Dirty filter cartridge
NOT HEATING
Water level is not at the minimum water line
PROPERLY
Heater failure
Filter pump broken
CAUSE
CAUSE
16
Change the water or contact local MSpa Service Center.
Contact local MSpa Service Center.
Add water above the minimum line.
SOLUTION
Check power supply
Reset GFCI by following GFCI Testing section
Contact local MSpa Service Center
Contact local MSpa Service Center
Set a higher temperature
Clean or replace the filter cartridge
Add more water to the minimum line
Contact local MSpa Service Center
Contact local MSpa Service Center
SOLUTION