Sulzer MIXPAC DB 2K Manual Original página 7

1. Remove nose plug (14) by rotating it counter clockwise
2. Set the adjustment wheel (11) to dispense the smallest
amount, setting 1, Set the Manual/Repeat switch (9) in "ma-
nual".
3. Press the trigger (10) until both components are evenly pres-
sed out of the cartridges.
5.1.3 Installing the static mixer
1. Remove any foreign matter on the cartridge and the cartridge
guide with a clean cloth.
2. Fix the mixer to the cartridge outlet.
EN
5.2 Apply the 2-component material
1. Press the trigger (10).
The compounds are pressed out of the cartridge into the static
■ ■
mixer.
The mixed material exits from the tip of the mixer.
■ ■
2. Adjust the material flow rate with the adjustment wheel (11),
to desired rate.
5.3 Cartidge removal
1. Press and hold the release button (8)
2. Pull the rack and rod holder (6)
3. Remove the cartridges.
4. Dispose of the used cartridges in accordance with the spe-
cifications supplied by the manufacturer, and/or local regula-
tions.
12
5.4 Transportation and storage
The dispenser is susceptible to shock, vibration, rain and severe
temperature fluctuations.
5.5 Decommissioning and disposal
The dispenser, accessories and packaging should be sorted for
environmental-friendly recycling.
The dispenser must not be disposed of with household garba-
ge. The various materials must be disposed of according to the
local regulations, laws and regulations pertaining to the country
in question.
Battery packs/batteries: Do not dispose of battery packs/bat-
teries into household waste, fire or water. Battery packs/batteries
should be collected, recycled and disposed of in an environmen-
tal friendly manner. According to local laws and regulations.
Always read the safety label and observe the di-
sposal instructions of the material manufacturer
6. Troubleshooting
Troubleshooting electric dispensers
No. Fault Cause
1 The dispenser does not work when No battery
pressing the trigger.
No battery power
The adjustment wheel, are in position
"0"
The stop (7) is activated.
2 The Manual/Repeat switch (9) is
The trigger cannot be pressed.
locked.
3 The dispenser piston is quickly driven The Manual/Repeat switch (9) is in
forward and then back. position repeat, and has stored a
short cycle.
4 The stop (7) is activated.
The light blinks.
5
The dispenser piston is driven back- For safety reasons, the dispenser has
wards, when pressing the trigger. a max. force, to prevent the cartridge
and cartridge holder to be damaged.
6
The dispenser piston is driven for- The cartridge is damaged.
ward, but no material is dispensed.
640082 ver. 1.0
Remedy
Install battery.
Check the power on the battery, if
necessary charges it.
Change the position.
Press release button (8),
and pull the racks back.
Change position.
Set the Manual/Repeat switch (9) in
manual, and record a new cycle.
Wait 30 seconds. If it is not stopped,
press release button (8), and pull the
racks back.
Check if the cartridge/mixer is blo-
cked. Check the temperature of the
cartridge. Adjust maximum speed.
Stop dispensing, and remove the
cartridge. Clean the dispenser.
13 EN