Maytag HAVS-1 Guía De Uso Y Cuidado página 12

Care & Cleaning
1.
.
3.
.
.
.
After washing, leave the lid open until the interior
is dry.
Check hoses to be sure there are no kinks or knots.
Your washer should not be installed where
temperatures will go below freezing, as damage to
the washer could result.
To clean, occasionally wipe exterior with a clean
damp sponge or cloth. Do not use polish on plastic
parts.
Lifetime lubrication is done at the factory, so your
washer never needs to be oiled or greased.
Do not lay heavy or sharp objects on top of your
washer.
.
.
10.
11.
The top of the washer should not be used for
removing stains from garments. Some stain
removers, such as rust remover, will mar the finish.
Remove pins, buckles or other sharp objects from
clothes to prevent scratching interior parts.
Clothes should not be stored in washer.
Bleach, detergent, solvents, etc. spilled on the top
of your washer that are allowed to remain will
remove the glossy finish. Remove all spills with a
damp, soft cloth.
If you close your home for the winter, have a service
technician drain the washer. Unplug cord from
electrical outlet and disconnect hoses from faucets.
Cleaning the Interior
The interior of the washer should be cleaned
periodically to remove dirt, soil, odor or bacteria
residue that may remain in the washer as a result of
washing clothes. We recommend taking the following
steps every 60 to 120 days to clean and freshen your
washer interior. The frequency with which the washer
should be cleaned and freshened depends on factors
such as usage, the amount of dirt, soil or bacteria being
run through your washer, or the use of cold water.
To clean and freshen the washer interior:
1. Add a measured amount of chlorine bleach to the
bleach dispenser, following package directions.
2. Add 1/4 cup of detergent to the tub.
3. Run the washer through a complete cycle using
hot water.
4. Repeat the process if necessary.
Troubleshooting
11
Won't Fill
Won't Agitate
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Turn the control knob to proper cycle and pull knob out to start the washer.
• Turn both faucets on fully.
• Straighten inlet hoses.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• Check fuse or reset circuit breaker.
• Make sure the lid is completely closed.
• Turn the control knob to proper cycle and pull knob out to start the washer.
• Close lid and pull knob out to start the washer.
• Pauses are normal. Wait and see if the washer will start again.