Checking The Memory Card; Electrical Connection - Air Techniques ScanX Swift View Instrucciones De Montaje Y Uso

7.5 Checking the memory card

NOTICE
Loss of image data due to unex-
pected insertion or removal of the
memory card
Insert or remove the memory card
i
only when unit is switched off
Checking proper insertion of the memory card
i
in the unit If the memory is inserted incorrect-
ly in the device, take it out again and re-insert
it properly

7.6 Electrical connection

Electrical safety when making connections
Connect the device to a correctly installed
i
power outlet only
Do not operate any other systems using the
i
same multiple socket
Make sure that none of the electrical cables
i
leading to the unit are under any mechanical
tension
Before initial start-up verify that the mains
i
supply voltage and the voltage stated on the
type plate match (see also "4 Technical
data")
2142100008L41 1708V002
OBJ_DOKU-0000002448-001-mehrere.indd 17
Connecting the unit to the mains supply
The unit has no main power switch For
this reason, it is important to set up the
unit properly such that the plug can be
easily accessed and unplugged if re-
quired
Requirements:
– Properly installed power outlet close to the
unit (observe the max length of the power
cord)
– Easily accessible power outlet
– Mains voltage matches the information
shown on the type plate of the power supply
unit
Attach the matching country-specific adapter
i
to the power supply unit
Remove the cover from the rear of the device
i
Plug the connecting plug of the power supply
i
unit into the connection socket of the unit
Installation
EN
US
17
24.08.2017 14:41:45