3. Grip the door on the two outer sides and
close it approximately half way. Pull the
door towards you, lifting it out of its slot (see
diagram). To replace the door, reverse this
sequence.
To remove oven door with soft closing hinges*:
1. Open the door completely.
2. Lift the pull-out hooks located on the two
hinges. If you cannot lift them manually, use
a tool as a lever.
3. Completely rotate downwards the pull-out
hooks.
4. Holding the door by its two outer sides,
slowly close it but not completely. Pull the
door to remove it from its seat (see figure).
To re-assemble the door follow the procedure
in reverse order.
5. Rotate the pull-out hooks upwards until they
touch the front of the oven.
*
Only available in certain models.
F
6. Push the pull-out hooks downwards,
making sure they are steady and do not
rotate forward.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged,
please contact your nearest Service Centre (see Assistance). We recommend
that the oven is not used until the seals have been replaced.
Replacing the light bulb
Lamp
Holder
compartment
Lamp
Glass cover
! Do not touch the light bulb directly with your hands.
! Do not use the oven lamp as/for ambient lighting.
Sliding rack kit assembly
A
Left
Right guide
guide rail
rail
B
C
To replace the oven light bulb:
1. Remove the glass cover of the
lamp-holder.
2. Remove the light bulb and replace
it with a similar one: halogen lamp
voltage 230 V, wattage 25 W, cap
G 9.
3. Replace the glass cover (see
diagram).
To assemble the sliding racks:
1. Remove the two frames, lifting
them away from the spacers A (see
figure).
2. Choose which shelf to use with the
sliding rack. Paying attention to the
direction in which the sliding rack is
to be extracted, position joint B and
then joint C on the frame.
29
GB