Publicidad
Idiomas disponibles
Idiomas disponibles
GB
D
! Do not place the sliding racks in position 5.
Automatic cleaning with the FAST CLEAN function
With the FAST CLEAN mode, the internal temperature of the oven reaches
500°C. The pyrolytic cycle is activated, burning away food and grime
residues. Dirt is literally incinerated.
Keep children away from the appliance during the automatic cleaning cycle
as surfaces may become very hot. Particles may ignite inside the oven as a
result of the combustion process. There is no cause for concern: this process
is both normal and hazard-free.
Before initiating the FAST CLEAN mode:
• clean the oven door;
• remove large or coarse food residues from the inside of the oven using a
damp sponge. Do not use detergents;
• remove all accessories and the sliding rack kit (where present);
• do not place tea towels or pot holders over the oven handle.
! If the oven is too hot, the pyrolytic cycle may not start. Wait for the oven to
cool down.
! The programme may only be started once the oven door has been closed.
To activate the Fast Clean programme:
1. Switch the control panel on by pressing the
2. Press the
button; the TIME display will show the default duration of
1:30 h (normal cycle), while he TEMPERATURE display will show "Piro" and
"nor" alternately;
3. The desired cleaning level can be selected by pressing the
- pressing " " to switch to the intensive cycle: the duration is 2 h and the
TEMPERATURE display shows the text "Piro" and "int" alternately;
- pressing " " to switch to the economy cycle: the duration is 1 h and the
TEMPERATURE display shows the text "Piro" and "eco" alternately.
Safety devices
• the door locks automatically as soon as the temperature reaches a high
value; the
icon lights up on the display;
• pressing the
button cancels the cleaning cycle t any time;
• if a malfunction occurs, the heating elements will be switched off;
• once the oven door has been locked, you cannot change the duration and
end time settings.
30
3. Secure the two frames with the
guide rails using the holes provided
on the oven walls (see diagram).
The holes for the left frame are
situated at the top, while the holes
for the right frame are at the bottom.
4. Finally, fit the frames on the
spacers A.
button.
button, then:
Programming delayed automatic cleaning
! Programming is possible only after selecting the FAST CLEAN mode.
1. Press the
button and set the end time using the " " and " " buttons.
2. Once you have reached the desired end time, press the
3. Press the
button to activate the programmed mode.
4. When the selected time has elapsed, "END" appears on the TEMPERATURE
display and a buzzer sounds.
• For example: it is 9:00 a.m. and the Economy (ECO) FAST CLEAN level
has been selected, with the default duration of 1 hour. 12:30 is scheduled
as the end time. The programme will start automatically at 11:30 a.m.
The icons
and
flash to indicate that programming has taken place.
After programming, in the time before the Fast Clean mode starts, the TIME
display indicates the duration and end of the Fast Clean mode alternately.
To cancel programming press the
Once the automatic cleaning cycle is over
Before you can open the oven door, you will have to wait for the
switch off: this indicates the oven temperature has dropped to an acceptable
level. You will notice some white dust deposits on the bottom and the sides
of your oven; remove these deposits with a damp sponge once the oven
has cooled down completely. Alternatively, you can make use of the already
heated oven, in which case it is not necessary to remove the deposits, they
are completely harmless and will not affect your food in any way.
button again.
button.
icon to
Publicidad
