Publicidad
Idiomas disponibles
Idiomas disponibles
Adjustments and Operation
Unfolding and Folding
The scooter is shipped in the folded and locked position. To unfold, lift the quick release
handle on the opposite side. This is an adjustable spring-loaded handle (fig.2).Turn the
spring loaded handle. This will allow you to lift the handlebars to the upright position. Lock
the spring-loaded handle into the small round guide hole. Clamp down the quick release
handle. Check for a secure lick. Reverse this procedure to fold. There is a tightness
control adjustment nut on the spring-loaded handle.
ADJUSTMENT
LIFT QUICK
RELEASE
HANDLE
Handlebars
Insert grips into handlebar T-Frame as shown in(fig.3).Be sure that snap pins fit into, and
lock, the small holes located at the top of the T-Frame.With the handlebars in the upright
and locked position, and the rider standing on the platform with ONE FOOT on the brake,
adjust the handlebar height to just below the rider's waistline. This is accomplished by
loosening the height adjuster (fig.3) while holding and tightening height adjuster. Be sure
height adjuster is tight again.
Installation of Seat (For models with seat only)
Press down the seat column into the hole on the main board, Ensure the snap pin
pops out and lock the piece properly, and clip firmly. Insert the seat into the upper
hole, use a spanner to tighten the locking net, ensure the seat is stable to use. The
seat can only be used with this product when the steering is completely locked.
This must be checked by an adult prior to use.
Power Switch
The scooter is equipped with a power ON/OFF switch located the right side of the scooter
footplate. When depressed to "ON",the power is on, and the motor and rear wheels cause
the scooter to move forward. When depressed to "OFF",the power is off, the scooter is
suggested to be charged on the position of "OFF".
FIG.2
SNAP PINS
go up
Handlebar T-Frame
go down
FIG.3
10
Grips
loosen up
squeeze
Publicidad
