Publicidad
Idiomas disponibles
Idiomas disponibles
Frame, Fork and Components
It is always important to check your scooter before driving. Check if it is cracked, or have
worn, broken or loose components that need to be repaired or replaced before driving.
Battery
Always make sure that the ignition switch is in the "OFF" position when the motorcycle is
not in use. Never store the product in freezing or below freezing temperatures. These low
temperatures will permanently damage the battery.
WARNING: Always make sure you are in the open area safe for walking before
you press the throttle. Never tell the accelerator without being on the bike in a
balanced way, ready to mount in position with both hands on the handlebar
controls.
It is always important to check your scooter before driving. Check for cracked,
broken, worn or loose components that must be repaired or replaced before
driving.
Repair and Maintenance
WARNING: Turn the power switch to "OFF" before performing any maintenance
procedure.
Adjusting the brakes: Tools required: 10mm wrench
1. To adjust the brake cable wire, turn
the adjuster drum on the brake lever
clockwise (to loosen) or anti-clockwise
(to tighten). Adjust the drum in small
increments to the desired setting. If
the brake still requires adjustment,
proceed to the next step.
WARNING: The brake may be capable of engaging and dragging the rear
wheel if no scooter is applied and may cause damage to the rear tire. Practice
using the brake in an open area without obstacles to become familiar with its
operation and can make smooth and controlled stops.
2. If the brake cable is still too tight, use
a 10mm wrench to tighten the brake
cable for additional adjustment on the
cable. Make sure that the 10mm nut is
tightened after adjustment.
14
Publicidad
