Publicidad
Idiomas disponibles
Idiomas disponibles
Remove the Footplate
Tools required: Phillips (Screw Driver).
The footplate(platform) is removable to gain access to the batteries. Simply remove the
four deck screws with a Phillips screwdriver, and lift off the platform. Reverse procedure to
replace.
Drive Belt Adjustment and Replacement
Periodic adjustment of the drive belt is highly required. The belt will become loose
after hours of operation. Thus, when this happens, the belt will make a popping sound
while accelerating. When this occurs, you must tighten the drive belt immediately. To
tighten the belt, slightly loosen near rear axle nuts and rotate the belt adjuster discs
equally. Tighten axle nuts and recheck belt tension.
Drive Belt Alignment
If you experience either the drive belt coming off the drive gear or the wheel gear or
rubbing against the scooter frame, there most likely is belt misalignment. To re-align,
carefully place the scooter upside down on a sturdy surface (table, stool, etc.) and
determine the direction of the belt-side movement. You will slightly need to move the rear
wheel left or right to re-align. To do this, slightly loosen axle nuts and rotate the belt
adjuster discs. Tighten axle nuts and check alignment by engaging power. Recheck
alignment after riding, readjust if necessary.
USE A PHILLIPS SCREWDRIVER
TO REMOVE PLATFORM
CAREFULLY REMOVE SCREWS, SPRING AND
BRAKE PEDAL TO GAIN BATTERY ACCESS.
PLATFORM
MOTOR
SIDE VIEW
DRIVE GEAR
PLATFORM
MOTOR
UNDERSIDE VIEW
DRIVE
BELT
BACK
WHEEL
BELT
ADJUSTER
DISC
BELT ALIGNMENT
AXLE NUTS
BELT
ADJUSTER
DISC
BELT
BELT ALIGNMENT
18
Publicidad
