Publicidad
Idiomas disponibles
Idiomas disponibles
7.Ensure that the adjusting
washers are correctly
positioned against the frame.
After tightening the axle nuts
with a 13mm wrench check the
alignment of the wheels and the
tread of the belt by turning the
wheel in the opposite clockwise
direction by hand. You may
need to adjust the washers to
align the belt.
Adjusting the Strap
Tools required: 4mm hex wrench, two 13mm wrenches, 10mm wrench, Phillips
screwdriver.
8.Re-tighten the brake arm
bolt with a Phillips screwdriver
and 8mm wrench.
10.Reinstall the side covers with a 4mm Allen key. Do not over
tighten the screws.
16
9.Re-tighten the brake cable
nut slightly with a 10mm wrench.
Publicidad
