ADE WS 2302 Instrucciones De Operación página 54

Start-up
General Information
‚ Proceed according to the order listed below and first
insert the batteries into the wireless outdoor sensor.
Only then can the weather station function without
flaws.
‚ Do not use rechargeable batteries, since their voltage
is too low (only 1.2 V instead of 1.5 V). This affects,
among other things, the precision of the measure-
ments.
‚ Where possible, use alkaline rather than zinc-carbon
batteries. Alkaline batteries last longer, especially at
low outdoor temperatures.
Wireless outdoor sensor
1. Push the battery compartment cover on the back of
the outdoor sensor open using a little force.
2. Insert two LR03/R3 (AAA) batteries as shown on the
bottom of the battery compartment. Observe the
correct polarity (+/-).
3. Slide the battery compartment cover back on.
Base station
Battery operation
1. Press down the locking tab of the battery compart-
ment cover and fold down the compartment cover.
2. Insert two LR03/R03 (AAA) batteries as shown on the
bottom of the battery compartment. Observe the
correct polarity (+/-).
54
Weather station with wireless outdoor sensor WS 2302