ADE WS 2302 Instrucciones De Operación página 63

Procedure:
1. Place the base station and the new outdoor sensors
close together.
2. Remove the battery compartment cover on the back
of the outdoor sensors.
3. Use the switches to set a separate channel for each
new outdoor sensor. Since the sensor included in the
scope of delivery uses channel 1 by default, select
channel 2 for the second sensor and channel 3 for the
third one.
4. Insert two batteries of the battery type indicated on
the bottom. Observe the correct polarity (+/-).
5. Replace the battery compartment covers.
6. Use the CH button on the base station to select the
corresponding outdoor sensor (1, 2 or 3) to display its
data.
− If desired, press the - button repeatedly until the
base station display shows
sensor number. This is the indication that the out-
door sensor data is automatically queried and
displayed one after the other.
− If the channel number is not displayed after
inserting the batteries, press the TX button on
the respective wireless sensor. This way, the
weather data is transmitted directly to the base
station.
Weather station with wireless outdoor sensor WS 2302
near the outdoor
63