L.B.White Premier 350 DF Manual Del Usuario E Instrucciones página 11

Connecting Regulator to
Gas Supply
WHEN USING PROPANE GAS:
1. Lift the tank's cover.
2. Assemble the gas components shown, depending on
heater type. Tighten connections securely. See Fig. 2.
FIG. 2
3/4 X 1/4 Bushing
3. Form the pigtail connector to ensure the regulator will
be supported by the tank, and the tank valve cover will
protect the regulator from weather conditions.
4. Thread connector's POL fitting counter-clockwise into the
tank valve. Tighten securely. See Fig. 2.
5. Open the tank valve.
6. Check all connections with an approved leak
detector. Close the tank's cover.
7. When storing or transporting the heater, ensure the
connector's fitting is protected from damage and dirt
entry.
WHEN USING NATURAL GAS:
--- The regulator only should be used if the gas supply
pressure to the heater is above the maximum inlet
pressure stated on the heater's dataplate.
--- Connect the regulator as supplied with the heater to the
natural gas supply line, using the appropriate
connections. (DO NOT USE THE POL/PIGTAIL FOR
NATURAL GAS INSTALLATIONS)
--- Gas supply pressure to the regulator must
be a minimum of 2 PSI/13.7 kPa.
Tank Valve
1/4 in.
POL
NPT
Pigtail Connector
Owner's Manual • Premier 350 2.0
Premier Ductable Heaters
Thermostat
If a thermostat is not needed or required, select Manual
setting on thermostat switch. See Fig. 3.
FIG. 3
If a thermostat is required, select the Thermostat setting
on the switch and remove the thermostat outlet cover.
Plug the thermostat cord into the thermostat outlet
receptacle. See Fig. 4. Use ONLY L.B. White thermostat
cord with plug. DO NOT use an inline thermostat plug
when plugging to thermostat outlet receptacle.
FIG. 4
Thermostat
Receptacle
Thermostat
Cord
* ALWAYS cover the thermostat outlet when not in use.
* DO NOT plug an appliance into the thermostat outlet.
* DO NOT plug the thermostat cord into a power
receptacle.
11
Thermostat Switch
Thermostat Switch